P082D

Gear Lever Y Position Sensor 1 Circuit Range/Performance

Q: Is it safe to drive with P082D?

Short trips are usually fine, but the transmission may shift roughly or limit itself. Have it diagnosed before the fault worsens.

Q: Can I just clear P082D?

It will clear, but it returns once the selector position signal goes out of range again until the sensor or wiring is fixed.

Transmission / gear selector Generic OBD-II Medium

What it means

P082D means the transmission control module sees a signal from the gear lever Y position sensor that is outside its expected range. This sensor reports where the shift lever sits, so a faulty reading can cause harsh shifts or a limp mode. The engine still starts and runs — this is a selector-signal fault, not an engine problem.

Medium

Can I keep driving? Usually drivable, but the transmission may shift harshly or drop into a limited limp mode — get it checked soon.

Real-world scan data

Seen in

scans in the past year

Found in

<0.1%

of scans

<0.1%

of scans that found faults

Figures reflect only diagnostic scans recorded through our own apps and tools. Cars are typically scanned because a symptom or warning light prompted it, so these counts describe our scan records — not the incidence of faults in any model, and not the quality, reliability, or safety of any vehicle. No comparison between manufacturers or models is implied. All trademarks belong to their respective owners; no affiliation or endorsement is implied.

Common symptoms

What you'll notice

Check-engine light on
Harsh or unexpected shift shock
Gear selector position reads incorrectly or intermittently
Transmission may enter limp mode or hold a single gear

Common causes

Most likely first

Wiring or connector fault at the gear lever Y position sensor (open, shorted, or corroded)Likely
Poor electrical connection in the sensor circuitCommon
Faulty gear lever Y position sensorCommon
Failed transmission control module (rare)Less often

How to diagnose & fix

Work through it in order

Read freeze-frame data and inspect the gear lever Y position sensor connector for damage, corrosion, or a loose pin.
Check the sensor's signal, supply, and ground circuits for continuity and correct voltage with a multimeter.
Compare the sensor's reading against actual lever position to confirm it tracks correctly.
Replace the position sensor if its signal is out of range with wiring confirmed good. Clear and re-test.

FAQ

Quick answers

Is it safe to drive with P082D?+

Short trips are usually fine, but the transmission may shift roughly or limit itself. Have it diagnosed before the fault worsens.

Can I just clear P082D?+

It will clear, but it returns once the selector position signal goes out of range again until the sensor or wiring is fixed.

Read & clear P082D yourself

Scan your car, confirm the code, and clear it once it's fixed — with OBD DashX on your phone.

▶ Get it on Google Play

✓ Verified name — SAE J2012 / ISO 15031-6Guidance reviewed by OBD DashX