P0D58
Circuito de detección de proximidad A bajo
Generic OBD-II
Qué significa
The proximity detection circuit A is reading lower than the module expects. The proximity circuit tells the vehicle that a charging cable is plugged in, and the car uses it to allow or block charging and driving.
Can I keep driving? Usually yes, as this mostly affects charging; get it read if charging fails. Do not open high-voltage (orange) cables or covers yourself; leave that to a trained technician.
Síntomas comunes
Lo que notará
- Charging does not start or stops after starting
- Charge port light or dash message shows a charging cable fault
- Vehicle may not detect the cable as plugged in
- Luz de aviso encendida
Causas comunes
Lo más probable primero
- Loose, corroded or damaged wiring or connector at the charge port proximity (cable-detect) line
- Dirt, moisture or damaged contacts in the charge port or on the charging cable plug
- Faulty proximity sensor or cable-detect resistor in the plug or port
- Charging cable or charging station fault giving the wrong signal
- Control module fault, or incorrect programming or calibration
Cómo diagnosticar & reparar
Siga los pasos en orden
- Try a different charging cable or charging station and see whether the fault follows the cable
- Inspect the charge port and plug for dirt, moisture, bent or burnt pins and clean them gently when unplugged and the vehicle is off
- Check the wiring and connectors from the charge port to the control module for damage or corrosion
- Check the charge port proximity sensor circuit readings against the service data with a scan tool
- Only then suspect the control module and have it checked or reprogrammed by a technician
Códigos relacionados
Lea y borre el P0D58 usted mismo
Escanee su vehículo, confirme el código y bórrelo una vez reparado — con OBD DashX en su teléfono.
¿Necesita un escáner que lea ABS, airbag y más? Los escáneres OBD GaragePro se envían a todo el mundo. Ver escáneres →